Everything to get your Motor running within half an hour!
The EZHR23SK Starter Kit combines one EZHR23 (3 Amp 40V) Stepper Motor Controller + Driver, an RS485 Converter, and all cables required for the first time user to get their Stepper Motor moving in less than half an hour. The user needs to provide only a power supply, stepper motor, and a PC.
The EZHR23 Stepper Motor Controller included with the Kit is preprogrammed with a short move sequence that will run the motor 200 steps in each direction 2 times. This happens as soon as power is applied. Initially no connection to a PC is required. Just connect your Stepper Motor, apply power and your motor will spin. (This power up sequence in the Stepper Drive can be erased or replaced with another sequence at a later time).
The second page of the EZStepper Wiring Diagram shows exactly how to wire the EZHR23 Stepper Motor Controller + Drive.
Once your motor is connected, connect the RS-485 Converter to your COM port on a PC and you'll be ready to start moving your motor. Please refer to the EZStart Document available on the website.
Let's Talk About Your Project
