EZHR23SK Stepper Motor Controller + Driver Starter Kit Description.
Everything to get your Motor running within half an hour!
The EZHR23SK Starter Kit combines One EZHR23 (3Amp 40V) Stepper Motor Controller + Driver, an RS485 Converter, and all cables required for the first time user to get their Stepper Motor moving in less than half an hour. The user needs to provide only a power supply, stepper motor, and a PC.
The EZHR23 Stepper Motor Controller included with the Kit, is preprogrammed with a short move sequence that will run the motor 200 steps in each direction 2 times. This happens as soon as power is applied. Initially no connection to a PC is required. Just connect your Stepper Motor, apply power and your motor will spin. (This power up sequence in the Stepper Drive can be erased or replaced with another sequence at a later time).
The second page of the EZStepper Wiring Diagram shows exactly how to wire the EZHR23 Stepper Motor Controller + Drive.
Once your motor is connected, connect the RS-485 Converter to your COM port on a PC and you'll be ready to start moving your motor. Please refer to the EZStart Document available on the website.
Kit Includes:
· One EZHR23 Stepper Motor Controller + Driver Board.
· One RS485 Converter.
· One Pre-Wired Opto Interrupter, for use as a home flag.
· All Cables
· Please download the most current documentation and software from the AllMotion Website.
Support links:
EZ Stepper Windows Application
Calculators:
"an" Mode Calculator (Pop up window)
"n" Mode Calculator - Servo (Pop up window)
"n" Mode Calculator - Stepper (Pop up window)